Work Stratix

Stratix

A scaffold is made of hundreds of tubes, couplers and plates that all have to fit exactly. I didn't want to place them by hand.

To make scaffolding that really adds up, I set everything up as procedurally as possible. First I modelled all the separate parts: tubes, couplers with nuts and bolts, rosettes, stairs and perforated plates. Then I built a tool in Cinema 4D that turns them into scaffolding by itself. You put down a few blocks as a rough shape and the tool fills them with standards, ledgers, braces, decks and stairs, with a coupler at every point where two tubes meet. Move a block and the whole scaffold builds itself up again.

Discipline
3D Animation, Motion Design, Styleframes
Duration
30 seconds
The scaffolding tool in Cinema 4D builds up a tower, seen from the front.
The scaffolding tool in Cinema 4D builds up a tower, seen from above at an angle.
The Stratix logo above a scaffolding tower.
A scaffolding tower of tubes, stairs and purple perforated plates.
A purple perforated plate between the tubes, with the mesh behind it.
A purple perforated plate between the tubes of the scaffolding.
Close-up of a perforated plate with large round holes.
Close-up of a purple coupler with nuts on the tubes.

More projects

See all projects